Skip to main content

What is Convection and Its Problem Example

In previous post we learned what is conduction and its example on heat loss through a pipe wall with insulation. In this post, I want to share what is convection and its problem example.

Convection is heat transfer between a solid and an adjacent fluids develops as a result of fluid molecular movement. Cold molecules replace hot molecules as they leave the solid surface. A thin layer or film next to the solid surface is where most of the resistance to this type of heat transfer occurs. Even though the bulk fluid flow is extremely turbulent, this layer still exists.

Convective heat transport is governed by Newton’s law of cooling.

Q = h ∙A∙ ∆T

Where:

Q = heat transfer (Btu/hr)

h = heat transfer coefficient [Btu/(hr∙ ft2oF)]

A = area (ft2)

∆T = temperature difference (oF)

Convective heat transfer is divided into two types, natural or free convection and forced convection. Read More

What is Conduction and Its Problem Example

In this post I want to share what is conduction and its problem example.

In contrast to general molecular motion or mixing, conduction describes the rate of heat transfer through materials as a function of vibrations and interactions between nearby molecules. Conduction always applies to solids and rarely to fluids.

There are several fundamental equations for steady heat conduction through some basic solid shapes, neglecting conditions of border:

Read More

A Simple Method to Evaluate Heat Exchanger Performance

In this post, I want to share a simple method to evaluate heat exchanger performance. One of the most helpful ways to evaluate the performance of heat exchanger is to determine its effectiveness by comparing the actual heat transfer rate to the maximum rate that is thermodynamically feasible. The simple formula is expressed below.

Where:

η        = effectiveness

Q       = actual heat transfer rate

Qmax    = heat transfer rate which would be achieved if it were possible to bring the exit temperature of the stream with the lower heat capacity, to the inlet temperature of the other stream. Read More

How to Estimate Time Required for Heating or Cooling

In this post, I want to share how to estimate time required for heating and cooling.

The contents of a large batch reactor or storage tank frequently need to be heated or cooled. In this circumstance, the physical properties of the liquor may change throughout the process, as well as the overall transfer coefficient. When estimating the amount of time needed to heat or cool a batch of liquid, it is frequently possible to assume an average value for the transfer coefficient. Steam condensing, either in a coil or some type of hairpin tube heater, is a common method for heating the content of storage tank.

It is reasonable to assume that the overall transfer coefficient U is constant in the context of a storage tank filled with liquor having mass m and specific heat Cp and heated by steam condensing in a helical coil. The rate of heat transfer is given by: If T s is the temperature of the condensing steam, T1 and T2 are the initial and final temperatures of the liquor, A is the area of the heat transfer surface, and T is the temperature of the liquor at any time t, then:

The time t for heating from T1 to T2 can be determined using this equation. If the steam condenses in a reaction vessel’s jacket, the same analysis may be applied.

Heat losses during the heating or, for that matter, cooling operation are not considered in this analysis. The heat losses increase naturally as the temperature of the vessel’s contents rises, and at a certain point, the heat supplied to the vessel equals the heat losses, making further increases in the temperature of the vessel’s contents impossible.

By increasing the rate of heat transfer to the fluid, for example, by agitating the fluid, and by minimizing heat losses from the vessel by insulation, the heating-up time can be shortened.

The amount of agitation that can be achieved in a large vessel is constrained, thus one attractive alternative is to circulate the fluid through an external heat exchanger.

Let’s see example below on how to estimate time required for heating or cooling. Read More